Sansui SLED4280 Manuel d'utilisateur télécharger pdf (Page 6)

How to attach the stand

NOTE:

• Unplug the AC cord from the AC outlet.

• Ensure that unpacking and transfer of the unit is carried out by two or more people.

• Before beginning this process, assure that the TV is laid on a clean, safe, and cushioned surface to avoid

any damage to the unit.

• Do not touch or press the TV-screen, glass might break under pressure.

Place the TV on its front onto a table.

Align the stand’s bottom-plate (supplied) as seen here.

It will ﬁ t in only one direction.

Hold the unit and attach the stand slowly, as shown in Figure 1.

How to remove the stand

When you transport this product, remove the stand and pack ﬂ at against the back of the unit in the carton. To

remove the stand, perform these steps in reverse order.

For wall mounting, the base must be removed. To disconnect the base/stand remove the 4 screws from the back

(see page 5).

Finally secure the bottom-plate with 4 screws (supplied) as indicated by the arrows in Figure 2.

Be sure to follow the instructions. Insufficient tightening or incorrect installation of the stand will not support

your unit correctly, and could result in damage or injury from tip-over.

•

LCD PANEL SIDE

Figure 1

Figure 2

Illustration is SLED4280

3CQ0821B_En.indd 63CQ0821B_En.indd 6 10/7/10 4:37:07 PM10/7/10 4:37:07 PM

1 2 3 4 5 6 7 8 9 10 11 ... 26 27

Pas de commentaire

Sansui SLED4280 Manuel d'utilisateur Page 6